A dense point cloud can hold hundreds of points per square metre, far more than a surface model, a volume or a quick look needs. Thinning keeps a share of the points so the file opens faster and shares more easily. The two common ways are to keep one point in every few, or one point per cube of a chosen size.
Two ways to thin
| Method | What it does | Use it for |
|---|---|---|
| One point in every few | Keeps every 10th point, for example. Dense areas stay dense and sparse areas stay sparse. | A smaller copy for viewing or sharing, quickly. |
| One point per cube | Splits the space into cubes of the size you choose and keeps the first point in each. | Even spacing for surfaces, volumes and comparing two surveys. |
One point per cube removes most points where they pile up, such as under a slow flight line or where two flights overlap, and keeps the points where coverage is thin. Its result is a little like the spacing of a ground survey.
Thin a file
- Open Point Cloud Clipper and drop the LAS or LAZ file.
- Under "Thin the points", choose one point in every few, and enter the number, or one point per cube, and enter the size in centimetres.
- Add an area, heights or classes if you need them as well.
- Save as LAZ or LAS.
The message after saving says how many points were kept and how many were thinned.
Choosing a cube size
- 2 to 5 cm: detailed models of structures, when the file is merely too large.
- 10 to 20 cm: site surfaces and earthworks volumes.
- 50 cm and more: large areas, quick checks and previews.
The cube size should be smaller than the smallest feature you need to see. Thinning after clipping to the site saves the most time: how to clip a point cloud to a boundary shows how. For a file that will be shared, LAZ keeps it smaller still, as LAS and LAZ explains.
Questions
Does thinning change the points that are kept?
No. The points kept are copied as they are. Thinning only decides which points stay.
Which point is kept in each cube?
The first one in the file. It is not moved to the middle of the cube, so every point kept is a real measurement.
Why can a cube size not be used for my file?
The cubes are measured in the units of the file. A file in degrees has no metres to measure them in, so use one point in every few instead.
Is there a limit?
One point per cube keeps track of about six million cubes. For more, choose a larger cube or a smaller area.