Mapping software builds a map by finding the same points in several photos. For that, each photo has to share most of its ground with its neighbours. That shared part is the overlap.
Front and side overlap
Front overlap is between one photo and the next along a flight line. It is also called forward overlap. Side overlap is between one flight line and the line beside it.
What the software asks for
Pix4D publishes these minimums in its image acquisition guide:
| Terrain | Front overlap | Side overlap |
|---|---|---|
| Most cases | 75% | 60% |
| Flat farm fields | 80% | 80% |
| Forest and dense vegetation | 85% | 85% |
Other software gives similar figures. Check the guide for the software you use.
From overlap to spacing
Overlap sets how far apart the photos are.
Spacing = ground covered by one photo × (1 − overlap)
Example. One photo covers 60 m of ground along the flight line. With 75% front overlap, the spacing is 60 × 0.25 = 15 m. With 85%, it is 60 × 0.15 = 9 m.
The ground one photo covers grows with height. Fly twice as high and each photo covers twice the distance, so the same overlap gives twice the spacing.
Check the overlap after a flight
Flight planning apps set the spacing for you. What matters afterwards is whether the drone kept to it.
- Open the Drone Flight Check.
- Drop in the flight's photos.
- Read the forward and side overlap in the result. A figure below 75% forward or 60% side is marked.
- Look at the map. Each rectangle is the ground one photo covers.
The tool works the overlap out from the lens and picture size each photo records, the height above the take-off point and the distance between photos.
Why the figure is an estimate
The tool assumes flat ground and a camera pointing straight down.
- Hills. Ground that rises towards the drone is covered by a smaller footprint, so the real overlap there is lower than the estimate.
- Take-off point. DJI photos record the height above where the drone took off. If the site is higher or lower than that, type the height above ground into the tool.
- Other drones. Photos that do not record a height above take-off need the height typed in.
For everything to look at after a flight, see How to Check Drone Photos Before Processing.
Questions
What happens with too little overlap?
The software cannot match the photos in that area. The result has holes, or the photos there are left out.
Is more overlap always better?
More overlap gives the software more to work with, but it means more photos, a longer flight and longer processing.
Does a missing photo break the overlap?
One missing photo doubles the spacing at that spot. With 75% front overlap the two photos either side still share half their ground. See Why Are Photos Missing from My Drone Flight?