A drone on a mapping flight takes a photo every few metres. When some are missing, the cause is usually one of five things. The Drone Flight Check shows which files are missing, where the gaps are and how much overlap is left there. That pattern points to the cause.
The usual reasons
| Reason | What you see |
|---|---|
| The card is too slow | Single photos missing here and there, more often late in the flight |
| The drone flew too fast for the photo interval | Even but wide spacing along every line, and low forward overlap |
| The flight was paused or interrupted | One gap, often with a break in the times |
| A battery change | A long break in the times, and sometimes a gap where the flight resumed |
| Files were not copied | Numbers missing in one block |
A slow card
The camera needs time to write each photo. If the card cannot keep up, the drone skips a shot. Use a card of the speed class the drone's maker recommends, and format it in the drone before a job.
Flying too fast
The camera has a shortest time between photos. If the planned spacing needs photos faster than that, the drone takes them as fast as it can and the spacing stretches. Slow the flight down or fly higher.
A fast flight also blurs photos when the light is low. The check marks blurred photos when you press "Check sharpness and exposure".
A pause or a lost link
When a flight is paused, the drone stops taking photos. On resuming, it may start a few metres further on. Check the gap on the map: if it sits where you paused, this is the cause.
Files not copied
Compare the numbering on the card with the folder on the computer. DJI drones start a new folder on the card after 999 photos, so part of a long flight can sit in a second folder.
Find the missing files
- Open the Drone Flight Check.
- Drop in the flight's photos.
- The result names the files missing from the numbering.
- The map shows where the gaps are, with the ground each photo covers.
- The notes give the forward overlap that is left at each gap.
Does the gap matter?
Look at the overlap at the gap. If the two photos either side still share half their ground or more, the software can usually bridge it. If the rectangles on the map barely touch, or do not touch, fly that part again.
Questions
Is one missing photo a problem?
Usually not, when the overlap is high. The photos either side cover the same ground. See How Much Overlap Do Drone Mapping Photos Need?
The numbering has a gap but the map shows none. Why?
The missing numbers were probably photos taken before or after the mapping lines, such as test shots that were deleted.
A photo is there but blurred. Does it count as missing?
For mapping, nearly. The software finds little to match in a blurred photo. Leave it out if its neighbours are sharp.