The altitude a DJI drone writes into each photo is often far from the true height above sea level. It can be tens of metres out, close to zero, or negative. If you load those photos into mapping software without ground control, the whole model sits at the wrong height.
How to check your photos
- Find the true ground height at your take-off point, from a survey mark, a site drawing or a topographic map.
- Add the height you flew at. If the ground is at 110 metres and you flew 40 metres up, the photos should read about 150 metres.
- Open a few photos in the Drone Altitude Fixer. It shows the altitude recorded in each photo and the height above take-off, side by side.
- Compare. A gap of more than a few metres is worth correcting.
What it looks like
| What you see | What is happening |
|---|---|
| The model or point cloud sits below ground, or at a height that makes no sense | The sea-level altitude in the photos is out |
| Every photo reads about 1 to 2 metres, though you flew much higher | A firmware fault wrote a near-zero value |
| Two flights over one site give different heights | Air pressure was different on the two days |
These are known problems, not a fault in your flight. Pix4D describes Mavic 2 photos loading with an altitude of 1.5 metres because of a firmware issue. In another case its staff found +1.20 metres stored for a flight at 50 metres. Agisoft says plainly that the height DJI writes is incorrect in some cases.
Why it happens
Most DJI drones without RTK measure height with a barometer. A barometer senses air pressure, and pressure falls as the drone climbs. That gives a good measure of how far the drone has risen since take-off.
It does not give the height of the take-off point itself. To write a height above sea level, the drone has to estimate that starting height, and the estimate is often poor. Air pressure also changes with the weather, so the same site can record different heights on different days.
The result: the height above take-off in your photos is usually sound, and the height above sea level is not.
Does it matter for your job?
- With ground control points, the software ties the model to surveyed heights, so a wrong photo altitude matters less.
- Without them, the photo altitude sets the height of everything: the model, the contours and any measurement taken against sea level.
- RTK drones record a far more precise height. This guide is about drones without RTK.
If your photos are out, correct them before processing. See How to Fix DJI Photo Altitude Before Mapping.
Questions
Is the horizontal position wrong too?
This guide covers altitude only. Check latitude and longitude separately by viewing the photos on a map in the Photo GPS Extractor.
Which altitude does my software read?
A DJI photo holds more than one. See DJI Altitude Fields Explained.
Will a firmware update fix it?
It can fix a firmware fault. It does not change how a barometer works, so the sea-level figure stays an estimate.
Sources
- Mavic 2 Pro Incorrect Altitude, Pix4D community, July 2019
- Correct altitude in image metadata, incorrectly read by Pix4D Mapper, Pix4D community, 2020
- Working with DJI photos altitude problem, Agisoft, last changed February 2026