The same point on the ground has two different vertical values. One is measured from the ellipsoid, a smooth mathematical shape of the Earth. The other is measured from sea level. They can differ by up to about 100 metres, so mixing them puts a survey at the wrong level.
The two values
Ellipsoid height is what satellite positioning measures. A GPS or RTK receiver works it out directly, from a simple shape that approximates the Earth.
Orthometric height is the value above sea level. It follows gravity, so water flows from a higher value to a lower one. Maps, building plans, flood levels and survey marks use it.
The geoid joins them
The geoid is the surface that mean sea level would take if it continued under the land. The gap between the ellipsoid and the geoid is called the geoid separation, often written N.
H = h − N
H is the orthometric value, h is the ellipsoid value and N is the separation at that place.
| Place | Separation (EGM2008) |
|---|---|
| Perth, Australia | About −32.9 m |
| London, United Kingdom | About +46.1 m |
| New York, United States | About −32.7 m |
In Perth the ellipsoid is below sea level, so a point at 20 m on the ellipsoid is about 53 m above sea level.
Geoid models
A geoid model is a grid of separations. Software looks up N at a position and applies it.
| Model | Covers | Use it when |
|---|---|---|
| EGM2008 | The world | You need sea level and no national datum is named |
| EGM96 | The world | Older software or a specification asks for it |
| AUSGeoid2020 | Australia | The job is in the Australian Height Datum (AHD) |
The two world models agree closely in most places: within 0.2 m over half of the Earth and within 0.65 m over nine tenths of it, with a few metres in rough terrain. Across Australia, AUSGeoid2020 differs from EGM2008 by 0.1 to 0.85 m in most places. For survey work that is too much to ignore, so use the model the datum names.
What a drone records
An RTK drone records the ellipsoid value. A drone without RTK works out its altitude from air pressure, which is a different problem: see Why Is the Altitude Wrong in My DJI Photos?
To change RTK photos from one to the other, use the Height Datum Converter. The steps are in How to Convert Drone Photo Heights to Sea Level.
Questions
Is orthometric height the same as altitude above mean sea level?
For practical work, yes. Both mean the value above the geoid.
Is the separation the same everywhere on a site?
No, but it changes slowly: millimetres across a small site and centimetres over several kilometres.
Which one does ground control use?
Usually the national datum, which is orthometric. A receiver can report either, so check the export settings and the survey report.
What happens if I mix them?
The whole model sits too high or too low by the separation. See Why Is My Drone Map at the Wrong Height?