A drone map can be sharp, correctly scaled and in the right place, and still sit tens of metres too high or too low. The size of the error tells you the cause.
Find the cause
| What you see | Usual cause |
|---|---|
| Everything is off by the same amount, between 10 and 100 m | Ellipsoid and sea-level values are mixed |
| Everything is off by under a metre | Two different geoid models, or a base station entered in the wrong datum |
| The error is different on every flight | The drone has no RTK and its altitude comes from air pressure |
| The model tilts or bows | Too little ground control, or weak overlap |
Mixed ellipsoid and sea-level values
This is the common one with RTK drones. The drone records the value above the ellipsoid. The ground control, or the level you expected, is above sea level. The gap between the two is the geoid separation: about 32.5 m in Perth, and anywhere from about −107 m to +86 m around the world.
To check, compare the error with the separation at your site. If they match, this is the cause. Ellipsoid vs Orthometric Height Explained covers the two values.
To fix it, convert the photos before processing:
- Open the Height Datum Converter.
- Drop in the photos.
- Choose the sea-level surface your project uses.
- Download the converted copies and process those.
The full steps are in How to Convert Drone Photo Heights to Sea Level.
An error under a metre
Two geoid models give slightly different answers. In Australia, EGM2008 and AUSGeoid2020 differ by 0.1 to 0.85 m in most places. If the photos were converted with one and the ground control is in the other, the model is out by that amount.
The same size of error comes from a base station position typed in above sea level when the drone expected the ellipsoid, or the other way round.
A different error on every flight
A drone without RTK works out altitude from air pressure, measured from the take-off point. The value drifts with the weather and has no fixed link to sea level. A geoid model does not fix that. Use the Drone Altitude Fixer, and read Why Is the Altitude Wrong in My DJI Photos?
Questions
Can I fix it after processing instead?
Often, yes. Shifting the finished model by the separation at the middle of the site is enough for a small site. Converting the photos is more exact, because each one gets the shift for its own position.
Does ground control fix it by itself?
Ground control pulls the model to its own values. The photos still disagree with it by the separation, which can slow or weaken the processing, so set or convert the photo datum as well.
How do I find the separation at my site?
Load one photo into the Height Datum Converter. The Shift column shows it.