A large drone job can produce an orthomosaic of 2 GB, 5 GB or more. Photo viewers refuse it, CAD software reports that the file is not valid, cloud uploads time out, and email is out of the question. The image itself is fine: the file is simply stored in a way that is too heavy for where it is going.
Why the file is so big
- Mapping software usually saves the orthomosaic with LZW compression or none, which keeps every pixel exactly but saves little space on photos.
- A fourth band holds the transparent edges, adding a quarter to the size.
- Files over 4 GB are written as BigTIFF, which many programs cannot read at all.
- Without overviews, a program has to read every pixel just to show the whole map.
Three ways to fix it
| Fix | What it does | Typical result |
|---|---|---|
| JPEG compression | Stores the same pixels with photo compression | Five to ten times smaller |
| Lower resolution | Half the resolution doubles the ground size of a pixel | About four times smaller again |
| Split into parts | Cuts the map into a grid of files, each in its place | Files small enough for any program |
All three are in Orthomosaic Compressor, which works in the browser and writes the result straight to disk in Chrome and Edge. The steps are in how to compress an orthomosaic.
Which fix for which program
- QGIS, ArcGIS, Global Mapper and web maps: a single compressed GeoTIFF is enough.
- Upload limits and email: compress, then lower the resolution if needed.
- AutoCAD and Civil 3D: JPG tiles with world files, as opening an orthomosaic in AutoCAD explains.
- Photo viewers: a quarter of the resolution, or the JPG tiles.
Before compressing, it is worth confirming the flight covered the site well: checking drone photos before processing catches gaps that no compression can fix.
Questions
Can I make it smaller without losing anything?
Only a little. Lossless compression such as Deflate saves some space, but photos do not compress well without loss. JPEG at high quality changes very little.
What size is small enough?
It depends on the program. Many CAD tools struggle above a few hundred megabytes, and some upload forms stop at 1 or 2 GB.
Do the split parts line up?
Yes. Each part keeps its exact position, so they meet without gaps or overlap when loaded together.